I'm very happy with the mechanics of my new Claymore... but the software is problematic.
I have the following problems
1) It does not appear possible to change the brightness setting of the numlock/capsloack/scroll lock status lights. Is the hardware implemented capable of a PWM control for these LEDs, if so how can I configure them to a lower brightness either by the config files or controller software?
2) If the answer to the above is not possible, is it possible to set these lights to not be used? They are far too bright! I would rather not have an indicator than have one this bright!
3) The software control has a limitation that you cannot set partial brightness in the colour selector, nor set the colours numerically. This means that while I can have 255, 0, 0 - I cannot set 160, 0, 0. Both are red but the latter is a significantly better level of illumination for me. It is possible to set this manually in the config file, then reload armoury - it is just a poor interface that does not have a full colour wheel selection, nor allow numeric entry of numbers.
4) Is there a way to disable the light from the logo, other than by not setting a light for the space key? Or are these two lights wired on the same circuit?
Thanks
Simon