Good evening everyone,
I am finally done with building my unobtrusive case. Only Ticket left on the to do list is to measure the water flow rate.
Here is where I am stumped. I am sure I am doing something wrong, just cant figure out what.
Motherboard is a Asus Maximus XI Hero (no Wifi) and the
Flow Sensor is a Aquacomputer G1/4" Flow Rate Sensor for Aquacomputer Aquaero.
The cable connecting the device to my motherboard is a Aqua Computer 53027 – Cable.
All of the above can be found on amazon.com (I did not want to use links as they may change).
So I connected the device to the W_Flow on my Motherboard, booted the computer up, pressed F2 to get into the BIOS. Checked under Monitor and it shows me N/A.
So clearly something is wrong.
Looking forward to advice from the community, cheers, Caipa.