05-06-2020 11:59 PM - last edited on 03-05-2024 07:58 PM by ROGBot
05-07-2020 10:06 AM
05-07-2020 10:22 PM
05-08-2020 12:13 AM
Hinopup wrote:
I have tried adjusting the XMP setting and manually setting voltage even going a little higher and lower. What ends up happening is the machine turns on and after a few seconds the post codes start cycling very quickly where its impossible to read them. This continues until you force turn off the machine. I have even tried putting in ram from another one of my machine and have the same problem. I am at a total loss. If you have a recommendation on a power supply with the additional 4 pin I would welcome it because It might just be time to start replacing parts.
05-08-2020 01:25 PM
Silent Scone@ASUS wrote:
Hello,
Memory parameters vary from vendor to vendor. You may want to try both Maximus Tweak Modes 1 and 2 as well as both XMP 1 and 2 profiles to see whether this remedies the instability.
06-15-2020 01:09 PM