Asus Z490 stuff

[GanjaHouse]

Have you tried other games? Some games scale better than others.

Yes with forza horizon

I Use this settings bios
https://drive.google.com/file/d/1J0p...BMj2dLQDm/view

[Falkentyne]

I don't use any kind of uncapped FPS.
My gpu uses 89/95% load only, never 99%

2. I don't use vertical sync and gsync is activated in full screen.
3. Right now I don't remember but I use the same oc in the cpu I haven't modified anything and the use of the cores seems normal.

Gsync activated--
there's your problem.
Gsync will only work at your monitor's refresh rate range. and there are settings where the FPS will get capped at or right below the refresh rate of your monitor (hz).

disable gsync and then use something like MSI Afterburner's RTSS and post your FPS. I bet your GPU will then be running at 100%.

[GanjaHouse]

Gsync activated--
there's your problem.
Gsync will only work at your monitor's refresh rate range. and there are settings where the FPS will get capped at or right below the refresh rate of your monitor (hz).

disable gsync and then use something like MSI Afterburner's RTSS and post your FPS. I bet your GPU will then be running at 100%.

But I have a native gsync monitor.
Vsync is disabled

[BloodBaron]

But I have a native gsync monitor.
Vsync is disabled

shouldn't V-sync be ON ?
https://blurbusters.com/gsync/gsync1...d-settings/14/

[GanjaHouse]

shouldn't V-sync be ON ?
https://blurbusters.com/gsync/gsync1...d-settings/14/

I have always used vsync and gsync activated, but in several places they say something different

[martine-dee]

Ah yes, there was an error in the manual that came with my M12E.

According to the manual, CPU_FAN is the right one of the two connectors. But following this gives the 'CPU Fan Error!'. I tried the left one just per plain intuition, and it worked. Now I see that the online manual is updated, and marks the left conector as the CPU fan.

Ftr, from my manual:


From the online manual:

[martine-dee]

Also, this bit of the supplied screw driver has the perfect length to help holding my 1080 Ti in the air. It has rubber on both ends, which is also perfect for holding in place.



The story here is that TT View 91 isn't really working well with my 1080 Ti, so the graphics card hangs with its full length off the external chassis panel. The View 91's triangular mount is placed too low and too far to be of any help holding the card. And it was also getting in the way of mounting the Asus ROG Strix riser cable to the card, so it is out.

But this accessory, I thought that it would have the prefect length for supporting the graphics card from the other end, and that was right.

[sladenlol]

When can we expect a new Bios for maximus XII hero with txp/ppd and improved ram Stability?
Cant even Boot cr1 3800 but 4700 cr2 works.

Tested 10 Gskill trident Z royal dual Kits.

[Enderwiggin03]

When can we expect a new Bios for maximus XII hero with txp/ppd and improved ram Stability?
Cant even Boot cr1 3800 but 4700 cr2 works.

Tested 10 Gskill trident Z royal dual Kits.

CR2 is typical for Intel, good luck getting CR1 at high ram frequencies.

[sladenlol]

CR2 is typical for Intel, good luck getting CR1 at high ram frequencies.

Thats Not true, on msi z490 unify (which is a 250€ board) i can run 4700 cr1, Same with apex 4700 cr1 no Problem.
So the Bios for hero XII is crap.