hello all,
i just built a new rig and went with mostly asus and and amd this time. (last time i went amd was over 20 years ago).
My hardware;
motherboard = ASUS AMD AM4 ROG Strix X570-E Gaming
CPU = AMD RYZEN 9 3900X
CPU cooler = Asus ROG RYUJIN 240 RGB
Graphics = ASUS AMD Radeon RX 5500 XT
ram = G.SKILL Trident Z Neo (For AMD Ryzen) Series 32GB x 2
fans = Antec Prizm 120mm
case = NZXT H510i
so far everything is fine other thatn an issue i'm having with my AIO cooler. first it took me a while to figure out what was making the loud fan noise. turns out it's the fan over the cooler heat sink.
it took me a bit to figure out the fan as ai suite 3 has,
1. aio pump, (with a question mark) set at full fan speed
2. w_pump, (with a question mark) set to full fan speed.
3. rog ryujin fan, think this ios for the 2 fans on the rad
4. rog ryujin fan 1, this is the fan over the heat sink wich i can lower to make the fan not soi loud.
5. chassis fan 1, top fan (works great)
6. chassis fan 2, back case fan (works great)
so i was thinking each fan ai suite would be better lableled as it's all asus, plus why do i have a reading for aio and water pump?
also i have cpu temp and fan speed set in the ryujin display, but i never see the fan speed it's always zero. even when i can hear the fan it still shows 0.
now if the system goes to sleep, the fan in the aio cooler above the heatsink gets loud again, if i log in it continues. the only way to stop it is to open ai suite 3 and change the fan curve then hit apply. when i say loud, the fan sounds like it's reving, like the fan is going from low to high pretty fast.
hope this makes sense and someone can offer some advice.
tnx