- last edited on by
ROGBot
Hello
im using a Barrow Water Temp Sensor to control my pump speed. Usually im used to have 30 degree water temp but sometimes (does not matter if load or idle)
water temp peaks to 128 degree (not always 128, it is also peaking to 120, 100, 90 or whateever. But always the same wihtin one cycle). The curve is like 30 - 128 - 30 - 128 - 30 - 128 - 30 - 128 for some seconds and after it remains on 30 for several minutes.
Here is a screenshot of icue. The last peak was 215 degree
Anyone else had this problem before or is there a know fix for this issue ?
Best Regards
Tobi
im using a Barrow Water Temp Sensor to control my pump speed. Usually im used to have 30 degree water temp but sometimes (does not matter if load or idle)
water temp peaks to 128 degree (not always 128, it is also peaking to 120, 100, 90 or whateever. But always the same wihtin one cycle). The curve is like 30 - 128 - 30 - 128 - 30 - 128 - 30 - 128 for some seconds and after it remains on 30 for several minutes.
Here is a screenshot of icue. The last peak was 215 degree
Anyone else had this problem before or is there a know fix for this issue ?
Best Regards
Tobi
System is a self built hardloop.
it is attached to W_IN as it is directly placed under the pump (Water IN).
W_OUTshould be placed on the outlet (loop to reservoir)
W_FLOW there is no water flow sensor connected yet.
There are 2 liters of water inside the system, water temp wont peak that way...
Also there is no reason reapply thermal paste as its not a problem with cpu/gpu or whatever but with the sensor itself / reading state of the motherboard. Is it usual for the mainboard to read 216 degree W_OUT if there is no sensor connected ?
I will try to get a different sensor and test with it. Maybe its a problem related to the sensor which should be unusual.
Today i had some strange behaviour of temps in HWMonitor which leads me to the conclusion i have to be a mainboard related problem.
the W_OUT behaviour is strange too, but there is no sensor connected. Also the min temp of 3 degree is not possible at all
it is attached to W_IN as it is directly placed under the pump (Water IN).
W_OUTshould be placed on the outlet (loop to reservoir)
W_FLOW there is no water flow sensor connected yet.
There are 2 liters of water inside the system, water temp wont peak that way...
Also there is no reason reapply thermal paste as its not a problem with cpu/gpu or whatever but with the sensor itself / reading state of the motherboard. Is it usual for the mainboard to read 216 degree W_OUT if there is no sensor connected ?
I will try to get a different sensor and test with it. Maybe its a problem related to the sensor which should be unusual.
Today i had some strange behaviour of temps in HWMonitor which leads me to the conclusion i have to be a mainboard related problem.
the W_OUT behaviour is strange too, but there is no sensor connected. Also the min temp of 3 degree is not possible at all
