I am putting together a new PC and have run into some trouble.
Rampage IV Extreme
64GB memory
2xPOW GTX590
2x3TB HD
1x480GB SSD
Aquaero 5
2 water pumps, tanks and radiators
9x120mm fans
4x80mm fans
Corsair AX 1200 gold
Plus a lot of sensors that will connect to the Aquaero
I have connected the Aquaero and the fans and it runs fine, but when I connect the motherboard and the graphics cards and 1 HD it only gets 5v standby power. If I disconnect the MB, HD and graphic cards I still only get 5v SB. Have to disconnect the power cord for some minutes (haven't timed it) before full power returns. Then running Aquaero is ok, but the second I reconnect the MB it turns off.
The other day I found a 30v mosfet regulator on the bottom of the case, but quite sure it's for the PSU tester (molex output isn't working) as it is produced for iPhone and iPad.
Any suggestions?
[/URL]