cancel
Showing results for 
Search instead for 
Did you mean: 

No post

Retired
Not applicable
I had the system working good and was doing cable management got it done and now when I push the start botton it just lites up the hd led and thats it.Vid card spins up to 100% and the rctweak it shows cpu initial
Board die or what?
4,881 Views
3 REPLIES 3

Retired
Not applicable
No beeps or I could figure it out better.

martin_metal_88
Level 8
Do a clear Cmos. It's not impossible that playing with cable crapped your bios. Also make sure all cable are long enough and not to tight. Also that they are well plugged. If I am right your board don't have a onboard pc speaker so unless you have some that are lying at home you will need to find some. Usually the local shop will give them or sell them for like 1$ if they are cheap 😛

Before going further, can I have your complete system spec please?
Martin_metal_88


Colenzo :Coolermaster ATCS 840 | Gigabyte's EP55-UD5 | Intel Core I7 860 @ 3.8Ghz | 4GB G.skill Trident 1600 | MSI GTX460 1GB HAWK Twin frozr | WD 640 black + WD 1TB green + WD 1TB Blue | Pionner DVR-216 | Silverstone Strider Plus 850W | Coolermaster Hyper 212 plus in push pull fan config |

Ask for more!

Eerazer
Level 7
I had a solid red CPU light on my first CHV board running an 1100T, I had no post either. The board was faulty & has been replaced.
CPU: AMD Phenom II 1100T X6 4.0GHz
Motherboard: ASUS ROG Crosshair V Formula
Memory: Crucial 8GB DDR3 1333MHz
Graphics Card: ASUS ROG Matrix GTX 580 Platinum
Hard Drive: OCZ Agility 3 60GB SSD Western Digital 500GB X2
Sound Card: Creative SoundBlaster X-Fi Titanium
Power Supply: Corsair TX850W V2
Case: Fractal Designs R3 Black Pearl
CPU cooling: Thermalright Silver Arrow
OS: Windows 7 X64 Ultimate
Monitor: HP 2510i 25"