Results 1 to 7 of 7
  1. #1

    AMD Bulldozer Breaks CPU Frequency World Record -

    Chew* one of our very own TeamROG members has broken the CPU-Z World Record. This is not just a specific CPU category record, this is the mother of all records. GLOBAL! The last CPU-Z HWBOT record was hit at Formula X by our very own TeamROG member Brian.Y with a Celeron hitting 8.2GHZ. Chew* has smashed it at 8.429GHZ with the new Crosshair V Formula! Check out's coverage on AMD's bulldozer press event!

    8429.38MHz is the new CPU Frequency World Record claimed by a near-production desktop version of AMD’s FX Bulldozer CPU! witnessed the event first hand in Austin, TX at AMD Headquarters on August 31st during an AMD FX pre-launch briefing, and the record is set to be confirmed by the Guinness Book of World Records and The new AMD FX record smashes AMD’s previous best of 7378.25MHz set with a Phenom II 955 Black Edition.

    Welcome To AMD

    AMD FX at sunrise

    Legend Of AMD FX

    Read on below for details on how the record was set, video of the action, what the record means to us, as well as pictures from throughout the demonstration. Is it worth reading on? 5Ghz for Bulldozer is commonplace with air cooling for under 100 dollars…keep reading!
    AMD Bulldozer World Record

    It’s worth saying again folks – 8.4GHz+ at 2.02Volts. Wow! We’ve obtained an exclusive validation screenshot, something you won’t find on any other site at this point so you can see for yourself!

    AMD Bulldozer World Record 8429.38MHz

    One remarkable part of this world record is that it was hit in just a couple days of final testing, with just a few hours of actually going after the record under the most extreme conditions. Those doing the overclocking, Brian Mchlachlan (Chew*) and Sami Maekinen, had also done some pretesting on these chips in the week prior when they found 8 CPUs that would hit 8Ghz on extreme cooling – that confirmed very promising potential with high voltage tolerance and frequency scaling under cold. Ultimately, the final run was achieved through a two-stage approach in which a Liquid Nitrogen (LN2) evaporator pot was used on the CPU throughout, while the final record fell using Liquid Helium (LHe). Check out the following video to see the LHe overclocking in action!

    AMD also produced their own final video cut from the demonstration:

    In the first stage, LN2 was poured from a thermos into the pot to cool the processor down to -190C. Once at that temperature, we were observing results of 7.8GHz at 1.9V and AMD felt the chip was promising enough to break out the REALLY cold stuff, Liquid Helium (LHe). LHe is the ultimate in cold for subzero cooling; it boils just a few degrees Celcius above absolute zero. It is so cold in fact, that after pre-cooling to -190C, they had to ensure all the LN2 had boiled off before switching out – the liquid Helium would freeze the Liquid Nitrogen in the evaporator and interfere with optimal heat transfer!

    LN2 Evaporator preparing for the record-breaking attempt

    In the second cooling stage, an attachment designed by Aaron Schradin was added at the top of the LN2 evaporator to secure the pipe which would provide a constant flow of LHe into the evaporator, and a nozzle was affixed near the inner base of the container which encourages turbulence as the LHe enters. So cold that it boils violently on contact with the base of the evaporator, a constant plume of LHe fog erupts from within as you can see from all of the pictures. The fog itself is cold enough that they rigged a motherboard box to fit on top of the evaporator and used fans to blow the fog away from the motherboard in an attempt to minimize the condensation that forms on the chilled components – that is why the cooling apparatus is largely obfuscated in many pictures.

    Liquid Helium Coolant Hose and Pipe

    Starting flow of liquid Helium

    Custom Fabricated Motherboard Box Fog Retention Mechanism'

    Fog after installing liquid Helium Feed

    Fog Plume Used to Judge Flowrate of Helium

    -223C probe reading - temperature accuracy gets coarse below -200C

    Liquid Helium cooling mount, iced over

    The PCIe section of the motherboard curling from extreme temperatures

    World Record Significance

    Still, unless you are intimately familiar with subzero overclocking like I am, or you just get excited by new records like I do, you may be asking what a CPU Frequency record matters to Joe Sixpack? Don’t let anyone – or any marketing – fool you. This record isn’t going to change the way you compute daily, it isn’t going to mean you hit 6GHz on air, and it isn’t confirmation of what other benchmark performance we should expect to see from Bulldozer. We’ll be bringing you the benchmark performance, air cooling OC results, as well as more subzero results soon, but you’ll have to stay tuned until we can bring you all of those tests in the not too distant future. All that said, results of “well beyond 5GHz” on air were claimed on cooling solutions priced below the $100 mark!

    The sign didn't say "Do Not Touch"

    But what does it really mean? The world record feat brings us a lot of excitement about the possibilities for Bulldozer, but we still should be asking what it really means. In recent years, the game of high frequency records was the sole domain of Intel processors, and only about 20 of their chips have ever recorded tipping the scale at over 8GHz though hundreds of overclockers have tried for years. But even Intel hasn’t had any current generation contenders on this playing field; Intel’s best record was set just last month on August 12th, 2011 when TaPaKaH hit 8308.94MHz on an old Cedar Mill chip. That still puts Intel over 100MHz behind AMD’s new record, and the latest AMD FX chips aren’t even available at retail yet.
    The old Cedar Mill record is worth looking at closer now despite the fact no self respecting person in the modern day hardware game would be caught with one in their rig. Intel’s 8.3GHz mark on Cedar Mill is rather telling in regards to what AMD’s Bulldozer holds in store for overclockers. With Cedar Mill chips half a decade old breaking records as recently as last month, and Bulldozer breaking the World Record before it hits market – without any doubt this is only the beginning for Bulldozer. AMD will be the first to hit 8.5GHz, and it will happen before long, the only question remaining is which overclocker will hit it first!?

    Bulldozer overclocked Voltage, Frequency, & VID
    Looking forward to the horizon, what about 9GHz? Yesterday most people would have told you that isn’t realistic. Today many would likely still say I’m stupid for posing the question. But I will tell you this. Pre-production chips historically only scratch the surface of what the architecture is capable of. Given time as fabrication processes and yields improve while more people get their hands on more chips, we could hear reports of AMD seriously flirting with 9GHz soon enough. Granted however, the frequency scales with cold especially well, and we were watching liquid Helium which is as cold as it gets… But given time and liquid nitrogen, I expect the overclocking community will continue pushing these boundaries as the architecture matures!
    Bulldozer Voltage Tolerance & Frequency Scaling

    Bulldozer is in fact built like a Bulldozer. It will take a lot of abuse and keep on pumping! Now keep in mind the voltages discussed here were under extreme cooling – voltage tolerance under subzero cooling is considerably higher than ambient cooling. However, even on subzero hitting voltages of 2V, 2.1V, or 2.2V is especially high – those are definitely in the range where typically on Phenom II the chip could very likely never run again. The previous AMD record of 7378MHz was hit on only 1.88V. Its safe to say Bulldozer can handle quite a bit of extra voltage compared to what we may have become accustomed to!
    Once you get your hands on one, watch your temps as always, and make moderate increases while confirming frequency is scaling with the increases. Do that, and you are likely to have a hard time killing one while finding a lot of headroom for your overclock. In passing conversation, Brian and Sami mentioned doing 5Ghz on air running fully multi-threaded benchmarks.
    Finally on the scaling perspective, the results are confirmed that like the Phenoms, Bulldozer has no cold bug and the colder you can take it the higher the frequency and voltage tolerance climbs. In this sense, Bulldozer should receive a warm welcome from the overclocking crowd. Unlocked multipliers come standard; it’s highly tweak-able with all the settings you’ve grown accustomed to from Phenom, and it likes strong cooling so you’ll get additional headroom from your air or water cooling investments!

    Bulldozer 8.140MHz at 1.944V

    At this point we will leave you with that, as sometime soon we’ll have further testing and the ability to talk about results you want that aren’t mentioned here! Ask question or make comments directly below this article, as I’ll be actively joining in the conversation. Also you can read AMD’s own press release, or review our AMD Phenom Overclocking guide that also applies to Bulldozer so you are ready when these chips hit the streets!

    Click here to read FULL story...

  2. #2
    ROG Guru: Black Belt Array Area 66's Avatar
    Join Date
    Jun 2011

    Finaly a good news about Dozer

  3. #3
    yes its pretty epic

  4. #4
    TeamROG Moderator Array xeromist PC Specs
    xeromist PC Specs
    Laptop (Model)Dell Inspiron 15 7567
    MotherboardMSI x470 Gaming Plus
    ProcessorAMD 2600X
    Memory (part number)16GB Crucial Ballistix Elite 3600
    Graphics Card #1ASUS GTX 1080 Strix
    MonitorBenQ BL3200PT
    Storage #1Intel 600p NVMe
    CPU CoolerWraith
    Casecustom Antec 900
    Power SupplyCorsair HX1000
    Keyboard Logitech Orion Spark
    Mouse Logitech MX500
    Headset Plantronics 777 with Oregon Aero upgrade
    xeromist's Avatar
    Join Date
    Jul 2010

    WTG chew*!!!!
    * Support disease research with Folding@Home *

    < < < Click the drop-down above my avatar for my PC specs!

  5. #5
    ROG Guru: Black Belt Array Area 66's Avatar
    Join Date
    Jun 2011

    I see this news this morning on XS, I return to see update and Brian make a post no news when we can expect to see Dozer on the shelf, I start to be excited now, with a good Water-Cooling will be interesting to see the OC we can achieve. I feel my 4,1 ghz 1090t will be outclass soon.

  6. #6
    ROG Guru: Orange Belt Array Cyrekk's Avatar
    Join Date
    Jul 2011

    This is fantastic! Congrats to Chewy! I am actually getting really excited about BD now!
    New member? Introduce yourself here, learn a little of what we are about here, and refer to some simple rules here.
    Though typically not required or enforced, here is a list of guidelines on proper forum etiquette.
    [Work in progress]
    The Crosshair GENE will come! - Show your support HERE!

  7. #7
    AntiMatter Guru ROG Array chrsplmr's Avatar
    Join Date
    Jul 2011

    Chew doesnt break, he SMASHES the WORLD RECORD....yes, awesome news indeed.

    I could not be happier that it was a ROG board that finally gave AMD bragging rights., do they owe you a check or what?

    Every penny from here on out that AMD makes has Chew/ROG stamped right on it....again, Congrats.

Similar Threads

  1. Replies: 0
    Last Post: 02-22-2011, 11:22 AM
  2. Asus does it again, AMD memory frequency record reaches new heights
    By chew* in forum Other Series Motherboards
    Replies: 1
    Last Post: 11-26-2010, 11:31 PM
  3. Crosshair 4 Formula sets a new AMD maxximum memory frequency record
    By chew* in forum Other Series Motherboards
    Replies: 1
    Last Post: 09-21-2010, 09:48 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts