- last edited on by
ROGBot
This is the Cooler Master CM 690 case mod project I've started for local customer... He will be doing finishing touches on it....
Hmmm..
Cooler Master CM 690, Before
Hmmm something is different...
Hmmm..
Cooler Master CM 690, Before
Hmmm something is different...
5.25 bay and rear I/O plate and 3x I/O shields painted "House of Kolor" Kandy Blue
Thank you!
Black Pop Rivets
http://www.mnpctech.com/Pop_rivets_for_computer_case.html
Most Computer Chassis will accept 1/8” diameter Pop rivets, Gripe range .092" - .125" for Computers.
You can also get Copper Pop Rivets and Rivet Gun from Mnpctech 😄
http://www.mnpctech.com/Pop_rivets_for_computer_case.html
Black Pop Rivets
http://www.mnpctech.com/Pop_rivets_for_computer_case.html
Most Computer Chassis will accept 1/8” diameter Pop rivets, Gripe range .092" - .125" for Computers.
You can also get Copper Pop Rivets and Rivet Gun from Mnpctech 😄
http://www.mnpctech.com/Pop_rivets_for_computer_case.html
2x 120mm machined fan/rad grill Mnpctech makes for PPCs. Joe may go with Anodized Black version instead, I'll piece everything together first and he can decide.
The 140mm intake in the floor will be relocated to bottom of the chassis, so I've made spacers to raise the 690. These are milled from 3/4" thick aluminum
These Black Anodized Thumbscrews look really nice with the custom painted Cooler Master 690 chassis
These Black Anodized Thumbscrews look really nice with the custom painted Cooler Master 690 chassis
Thank you!!!
CM690 spacers and feet anodized Black
CM690 spacers and feet installed
The outter edge of the feet will be flush with the side panels.
CM690 spacers and feet anodized Black
CM690 spacers and feet installed
The outter edge of the feet will be flush with the side panels.
The access side panel window mounted.
