1st of all, you're uploaded the same screenshots twice, that's pretty much confusing.
Also we need some more info about your PC configuration (RAM model especially).
Oh man, you're made a lot of mistakes.
You can refuse your VCCSA and VTT voltages, that's for sure. 1.2 or even less. Also newer left it on auto.
Vcore is also pretty high, I guess you can lower it too.
XMP profile is not the best way to tune your RAM, this profile can contain some voltage settings that you should set manually.
As a starting point, just set timings from XMP manually.
Also it would be better if you'll set strap and multiplier manually.
You haven't posted some screenshots of important settings, I mean DIGI+ power control and CPU settings.
(Maybe you haven't set LLC so you need such high vcore)
If you wanna run some SuperPi you have to set 2nd ant 3th timings manually but that's another story.
Drop your voltages and upload some more info and we'll continue.
Edit:
Ok I've found your ram model on 32m Pi sctreenshot in SPD tab. RipjawsZ 1866 4x4 1.5v
That means you have to drop dram voltage too. 1.55-1.6 will be fine I guess.