I'll have to drag out some photos of my Harry Potter build (its ugly and scarred and lives under the stairs 😉 )

Asus P5E
Intel E6850 @ 3.2Ghz cooled with a Noctua NH-C14 (one fan)
Kingston HyperX 4x1Gb @ 1066Mhz
MSI HD5450 (needed something for a graphics interface, and I am actually very surprised by its performance, no problems with MW3, doesn't like BF3 though lol)

I just use it for a spare when my main rig is in pieces, its either folding, downloading or being used as a spare.

Folding at 100% CPU it doesn't go over 42° 🙂

So here is Harry Potter

Case: Advance (not sure which one and heavily cut about)
Mobo: Asus P5E
CPU: Intel E6850 @ 3.2Ghz (maybe more when I get around to it)
CPU Cooler: Noctua NH-C14 (using only 1 fan)
Ram: Kingston HyperX 4 x 1Gb @ 1066Mhz
GPU: MSI HD 5450 passively cooled
PSU: Corsair HX750 (over 5 years old so I should imagine that I'm getting less than 600W with it)
HD: Samsung Spinpoint 250Gb

Cable management is not possible with this case, normally the PSU should be top front (wouldn't fit) so is now bottom front on its side, HD and bays taken out for that, HD bays riveted back in above the PSU
Side panel already had 1 round hole, I cut a second hole (square) for the PSU intake. Household aluminium vent covers riveted to side panel.

Yes I know, I need lots more practice with a Dremel before attacking my main rig lol





Case isn't wonky, its my camera lens that did that.



And a little "dusty" close up to finish 😉