Hello, I bought my motherboard in feb and I just open it up today. I've been doing alot of mods on my phantom 820 case and getting my water cooling parts. I had to buy when I had the money to. So it took a little bit.
I'm ready to put my build together so I got everything out of the boxs. Doing the pre test before I put everything in the case.
I'm testing all my components and I have one dram that doa so I have to rma that pair.
I have i7-3770 K, 16GB of trident x ram (only 8GB installed), two samsung 840 series 120GB SSD and a 1TB western digital hard drive, two asus 680 DC2O and seasonic 850 watt power supply.
Both 680s and the three hard drives all work. I tried them on my brother PC.
So what happens is, it goes through the leds and stops at the (boot_device_led). the Q-code shows a A2.
The bios is not showing up on the monitor. It does nothing. I've plug the hdmi in the back of the mother board and then I tried one 680 plug in at a time with the hdmi. NOTHING!!!
I've tried all the 3/6 sata connectors, and I even power down and press the bios reset in the back for 3 sec and boot back up and still the same thing. Can someone please help me out. thanks
Phanteks enthoo primo, i7-4770k, ASUS MVIF, 16GB G.Skill Trident X Ram, ASUS 780 Ti DC2O, Samsung 120GB and crucial M500 480gb SSD, 1TB Western Digital Hard Drive, NZXT 850W power supply
EK Supremacy, EK ASUS MVIF Water Block, EK Monarch Series X4 Ram, EK ASUS 780 Ti DCII, EK 420 Cool Stream Rad, XPSC 240mm RAD,Monsoon Series Two Dual Bay Reservoir, Swiftech MCP655-PWM-Water Pump, Monsoon Compression Fittings & Tubbing, Mayhems Pastel Red with Mayhems ultra pure h20.