Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Rampage IV Extreme Power problem

as_mail2007
Level 7

‎05-08-2013 08:55 AM - last edited on ‎03-06-2024 09:11 PM by Community Admin

hi everyone

i just purchased rampage iv extreme yesterday, tried it last night and after about 20 minutes it turned off, and today, i turned it on again and after about 30 minutes , it turned off and i can't turn it on again

there's no code in debug LED, and Start,Reset,Bios LEDS are on

when i want to turn it on, very low knock noise come out from PSU, and fans move abit


what did i do?

- tested all of my computer parts, all of them are ok
- disconnected everything and tried to turned it on with power cables + cpu + 1 ram
- swap bios
- put out battery
- trying to update bios, its old ROM series, so i tried to install CAP Converter but after a minute or two it seems that it want to turn on the system but it fails , so i can't update bios


can you help me please?
Labels:
0 Kudos
5,749 Views
9 REPLIES 9

Chino
Level 15

‎05-08-2013 09:27 AM

Welcome to the Republic of Gamers forum, as.mail2007@gmail.com. 😛

Please list your complete system specs as detailed as possible for us. Thanks.
Overclocking The Core i7-7700K With DIP5 |Overclocking the Strix GTX 1080 | OC Panel & OC Panel II Guide | Overclocking i7-6700K to 4.6GHz | R5E 128GB DDR4 Setup | Liquid Cooling GTX 980 Ti Poseidon | R5E M.2 FAQ
0 Kudos

as_mail2007
Level 7
In response to Chino

‎05-08-2013 09:43 AM

hello

here you are:

CPU: Intel Core i7 3820
Cooler: Corsair H100
PSU: CoolerMaster GX750W
Ram: 2*4GB Corsair Vengeance 1600Mhz
VGA:Sapphire 7950 Dual-X
HDD: 1TB Western Digital Black Edition
0 Kudos

Aceswild
Level 7

‎05-08-2013 10:23 AM

Do you have power going to your four pin right about your video card.
0 Kudos

HiVizMan
Level 40

‎05-08-2013 10:51 AM

Ensure that all your 12 volt CPU power connectors are populated if possible. Check each connection to see that there is a proper fit.
To help us help you - please provide as much information about your system and the problem as possible.
0 Kudos

as_mail2007
Level 7

‎05-08-2013 11:02 AM

my VGA needs 2*6 pin connector, and it works fine, already tested

and about power connectors, yes, i'm sure they are fine, also i tested my power on m4a79t delux and it works fine
0 Kudos

Aceswild
Level 7

‎05-08-2013 11:12 AM

I just know that four pin on the mother board needs power, I actually ran for about two weeks before I started having problems and they sound real similar to yours, and of course I couldn't see that port after the radiator was installed so it was kinda tricky to get to it,,messed up my cable management to.
0 Kudos

as_mail2007
Level 7

‎05-08-2013 11:17 AM

the power cables i've attached to the main board is:

1 x 24pins for motherboard "EATXPWR"
1 x 4 pins + 1 x 8 pins for cpu "EATX12V_1" "EATX12V_2"
1 x 6 pins + 1 x 4 pins for EZ "EZ_PLUG1" "EZ_PLUG2"

anything esle that i must connect to the mainboard?
0 Kudos

Aceswild
Level 7

‎05-08-2013 11:47 AM

That's all the connectors I have.
0 Kudos

HiVizMan
Level 40

‎05-08-2013 02:01 PM

Nope that is perfect and your board is still not powering up.?

You have tested the PSU I see on a working board.

RMA the motherboard.
To help us help you - please provide as much information about your system and the problem as possible.
0 Kudos