Hi peeps aint been on here in a while and need some advice please.
Im using connect on my laptop ver. 1.04.16 and almost all works fine, i booted up my rig remotely im getting temps and can make adjustments no probs so all is well. But for some reason the flipping gpu tweak shows error msg telling me of an unsupported vga card and im assuming two asus gtx 680 dcii are supported but not 100% sure. Last time i used this software was with a 580 dcii and a different model of laptop i never had this issue last time so im a little stumped. I have been checking for threads on this issue but cant find an answer, any help would be great. Using a crosshair v formula if thats of any relevance. Hope to be bowled over by comments about how dumb i am and how easy the solution is. Cheers peeps.