09-22-2013 09:30 PM - last edited on 03-06-2024 07:34 PM by ROGBot
09-22-2013 09:52 PM
09-22-2013 10:09 PM
09-22-2013 10:37 PM
Alvaro Suarez wrote:
Thank you Abula for your quick reply.
The pump is a 3-pin connector connected to the CPU_FAN
The fan-radiator is a 4-pin connector connected to the CHAN_FAN2
I have the CPU Fan set as 'Advance Mode' in the CPU Q-Fan Control in the Bios since the manual states "Advance Mode - When a 3-pin CPU fan is installed, select this mode for the DC mode Q-Fan Control"
Not using a splitter. Should I?
Also, my Xpert2 profiles work fine, its just at startup that I get ZERO rpm on the CPU Fan,,, is there a way to just load my fan profile at startup?
09-22-2013 11:00 PM
09-23-2013 09:54 AM
09-23-2013 10:10 AM
Alvaro Suarez wrote:I never really messed with rpm mode, but i would think its a fixed rpm, no increase or decrease with temps.
In Xpert 2 for my CPU Fan settings, there is a RPM Mode, once I set it to that and manually set my Fan Speed after rebooting now CPU Fan works fine now. Though I don't the AUTO Fan monitoring its better than the ZERO rpm. Thank you.
09-23-2013 07:52 PM
09-24-2013 07:50 AM
Abula wrote:
I still will suggest that you switch the PWM fan to the CPU_FAN header, its the only true PWM fan header, even if the others headers have 4pin they are not true pwm fan headers, so they are adjusted via voltage. Some PWM fans dont like this, and become unstable. Since you pump is 3pin, i see no reason to have it on the only PWM fan header you have, it will behave the same as in CHA_FAN header, where the PWM fan could benefit not only out of working how it was design but might reach lower. Here is an example using the same PWM fan on different headers[/IMG]
09-24-2013 08:28 AM
Alvaro Suarez wrote:Nice that it worked out, glad to help.
That worked,,, makes sense after you explained it,,, many Thanks!