- last edited on by
ROGBot
Hi!
So here i am, all giddy over my new build.. Biggest Baddest and most expensive build i have ever done (Check my Signature)
So my first question is this since not all of my hardware has arrived yet.
Will the Rampage IV Extreme Black Ed. fit in a NZXT H440? or is my dream crushed before i even start building it? 😞
Second question.
I have
4x Noctua NF-F12-PWM For the push n' Pull configuration
4x Noctua NF-S12B-PWM Redux 1200 top and front of chassis
1x Noctua NF-A14iPPC-3000 PWM For the back of the chassis
And im planning to use a 5 way 4 pin PWM to control at least 8 of the fans since there are only two PWM ports(CPU and CPU_OPT) on the R4BE.
Thanks for reading this.
Johan
So here i am, all giddy over my new build.. Biggest Baddest and most expensive build i have ever done (Check my Signature)
So my first question is this since not all of my hardware has arrived yet.
Will the Rampage IV Extreme Black Ed. fit in a NZXT H440? or is my dream crushed before i even start building it? 😞
Second question.
I have
4x Noctua NF-F12-PWM For the push n' Pull configuration
4x Noctua NF-S12B-PWM Redux 1200 top and front of chassis
1x Noctua NF-A14iPPC-3000 PWM For the back of the chassis
And im planning to use a 5 way 4 pin PWM to control at least 8 of the fans since there are only two PWM ports(CPU and CPU_OPT) on the R4BE.
Thanks for reading this.
Johan
It will be fine to what question? the fans or the chassis?
Yeah, the fans will no doubt fit problem is if the mobo will fit since the board is eATX and the chassi is not
But the chassis has quite a lot of space in it, tho it might overlay on the rubber pass trues. As long as the mounting holes line up then I can mod it to work.
Time will tell I think the mobo will arrive this week.
Question two was supped to be "is it a good idea to control 8 fans on two PWM ports."
But the chassis has quite a lot of space in it, tho it might overlay on the rubber pass trues. As long as the mounting holes line up then I can mod it to work.
Time will tell I think the mobo will arrive this week.
Question two was supped to be "is it a good idea to control 8 fans on two PWM ports."
The fans uses power from a separate MOLEX and just use the PWN contacts for PWM management 
thats the splitter im going to use.
thats the splitter im going to use.
HiVizMan wrote:I will absolutely do that.Do you know if it will work to run so many fans on so few ports HiVizMan?I'll do my posting about this build with pictures on the right part of the forum when it's time.
Post some pictures when you are done mate.
Just thought i would add the first picture of some of the items that has arrived. 🙂
