cancel
Showing results for 
Search instead for 
Did you mean: 

CPU Fan Setting for Corsair H70 Question

Retired
Not applicable
Installing my Corsair H70 cooling kit tomorrow and I need my CPU Fan to stay at 100% power but I cant figure out how. In the bios I have the CPU fan set to TURBO but the fan does not stay at full power. What do I set in the bios so it stays at 100% power for the H70 Pump?
11,581 Views
7 REPLIES 7

xeromist
Moderator
Do you mean an H70? The A70 is an air cooler.
A bus station is where a bus stops. A train station is where a train stops. On my desk, I have a work station…

Retired
Not applicable
You are correct. I should have said H70. And corrected original post where i could.

xeromist
Moderator
Hrmm, I don't recall this being an issue when I installed my H50. Do you have reason to believe that the H70 is going to have a problem?
A bus station is where a bus stops. A train station is where a train stops. On my desk, I have a work station…

pcjunkie209
Level 9
well u could run a dummy fan to cpu plug on mobo and hook h-70 up to molex????
"I would rather be gaming!" Grunts-clan.com
[SIGPIC][/SIGPIC]
http://Pcjunkiemods.com
http://c2cmods.com

Retired
Not applicable
I like that idea. I think I'll try that.

pcjunkie209
Level 9
That will give you 12v continuous power which will keep rpm and pump at 100%
"I would rather be gaming!" Grunts-clan.com
[SIGPIC][/SIGPIC]
http://Pcjunkiemods.com
http://c2cmods.com

Retired
Not applicable
or you can swap the corsair fan for something with a rheostat to adjust your fan speed. something with some higher cfm if you don't mind the noise