Hi RextonETS, and welcome to a fellow Texan
BSOD with code 124 is quite common when overclocking. The remedy is usually to increase CPU Core voltage. I know you're not overclocking, but the same fix may be in order since the logger points to a core error.
I'm guessing that BIOS Vcore control is set in offset mode, or perhaps adaptive. The suggestion is to add +.05 additional offset. Even if using manual voltage control, raising Vcore about .05 volts can help.
If BSODs happen less often, but still happen, with that change, try another +.02 volt increase. Heat issues can crop up with an air cooler when Vcore goes over 1.25, so go slow when you get near that level.
Hope this helps
Jeff