I am using ez setup. p1 is = ocz vertex 3. p2 is = dvd/cd drive.
When i save these settings, pc does not reboot; it just powers down.
Is their a long wait time to save the setting in bios, before restart occurs?
When I push the power button on the pc, it just powers up briefly, than goes off again.
The only way to get a post, is to use the clear CMOS button, then do F1 for a setup.
Once in bios setup, i have to do overide boot settings to P1 (ocz vertex 3). This will boot to win7, but it is very slow to start up.
Also memory cannot run @ 1600. I get overclock failed message. It runs @ 1330.
Intel Core i7-2600 Processor 3.4GHz
OCZ 120 GB Vertex 3 SATA III
Western Digital Caviar Black 750 GB SATA III 7200 RPM 64 MB
HIS PCI-Express Video Card (H687F1G2M)
Corsair Vengeance 8 GB ( 2 x 4 GB ) DDR3 1600 MHz
Corsair Enthusiast Series 750-Watt 80 Plus