Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

EZ setup ?

Retired
Not applicable

‎11-16-2011 06:04 AM - last edited on ‎03-05-2024 07:43 PM by Community Admin

I am using ez setup. p1 is = ocz vertex 3. p2 is = dvd/cd drive.
When i save these settings, pc does not reboot; it just powers down.

Is their a long wait time to save the setting in bios, before restart occurs?

When I push the power button on the pc, it just powers up briefly, than goes off again.
The only way to get a post, is to use the clear CMOS button, then do F1 for a setup.
Once in bios setup, i have to do overide boot settings to P1 (ocz vertex 3). This will boot to win7, but it is very slow to start up.

Also memory cannot run @ 1600. I get overclock failed message. It runs @ 1330.

Intel Core i7-2600 Processor 3.4GHz
OCZ 120 GB Vertex 3 SATA III
Western Digital Caviar Black 750 GB SATA III 7200 RPM 64 MB
HIS PCI-Express Video Card (H687F1G2M)
Corsair Vengeance 8 GB ( 2 x 4 GB ) DDR3 1600 MHz
Corsair Enthusiast Series 750-Watt 80 Plus
Labels:
0 Kudos
5,154 Views
1 REPLY 1

xeromist
Moderator

‎11-16-2011 10:58 AM

I would do your failsafe booting process and make note of the memory settings that it chooses. Set those statically and use that as a starting point for clocking them up after you have everything else stable. What happens if you reverse the order of the drives? Any difference?
A bus station is where a bus stops. A train station is where a train stops. On my desk, I have a work station…
0 Kudos