Hey all, I have not changed my signature of late, but I made the decision and built a custom loop.
It's and EK Kit; however; because of the room inside of the Corsair 780 T, I could not fit the standard radiation in the 'Pull' config.
Ended up with a 360 mm XSPC Slim.
The problem I have is when I went to install a 45 deg compression fitting, I noticed that my tubing is all discolored.
So my questions are?
Do I have to replace it, if so, what with?
What is causing it?
And finally, I will naturally have to clean the whole system, what with.
The kit has only been installed for less than 3 months.