I installed 3 new fans, 2 WPM fans for a Corsair H110 CPU radiator and the other a case fan for exhaust im not sure which is causing the message "CPU fan error! Press F1 to run setup" (maybe the H110 pump on the CPU header?) I get it when I boot the PC at any time and I press F1 to end up in the BIOS where I just exit the BIOS without saving to start Windows, Im using a Rampage 4 black edition motherboard and Noctua fans, I installed the PWM fans on a 4 pin header and the case fan is also on a 4 pin header too is this a BIOS setting not set correctly?