cancel
Showing results for 
Search instead for 
Did you mean: 

Code "AF" is this the end ?

caramba1
Level 7
Power up the system and get no boot: q codes "13" then "AF", cpu led near 24pin coonector is lighting red.
Trying everything: removing the battery, switching bios (bios1_1502 & bios2_1103), "CLr Cmos", "Safe boot", "Mem Ok", "Retry Button", reflashing bios, change Vga's, removing ram (exept 1slot), disconectiing all usb, ssd/hdd, hdmi and displayport, also checking the pins on the socket and reinstaling the cpu - nothing, just "AF" ...

Who is dead: 5820k or r5e ?
For some reason I think this its cpu.

5820k
r5e/u3.1
64gb(8x8Gb) corsair lpx ram
asus strix gtx980
500gb 850evo
2x 3Tb WD Green
Corsair HX1000i
12,385 Views
10 REPLIES 10

Arne_Saknussemm
Level 40
I would try a different PSU if you can before calling it "the end"...also try a new SATA cable on a couple of different drives

caramba1
Level 7
Need to try PSU on the other system.
But its new and working ok on r5e, the age of all config is about 2 weeks old.
All sata and usb are disconected...

Arne_Saknussemm
Level 40
So was working fine right? you say you suspect CPU...can I ask why? It was overclocked...etc?

You have fan plugged to CPU fan header?

caramba1
Level 7
There was last changing in bios settings when "AF" happaned:
Ai Overclock Tuner - Manual
CPU Strap - Auto
PPL Selection - SB PPL
Filtr PPL - Low BCLK Mode
BCLK Frequency - 100.0
Initial BCLK Frequency - Auto
ASUS Multicore Enhancement - Enabled
CPU Core Ratio - Sнтс All Cores
1 - 6 Core Ratio Limit - 43
Min CPU Cach Ratio - Auto
Max CPU Cach Ratio - 40
Internal PPL Overvoltage - Enabled
BCLK Frequency : DRAM Frequency - Auto
DRAM Frequency - 2400 Mhz
Enhanced IntelSpeedStep Technology - Enabled
Turbomode - Enabled
Load Line Colibration - 8
CPU Power Duty - Extrem
CPU Curent Capability - 140%
CPU Integrated VR Fault Management - Disabled
CPU Integrated VR Effciency Management - High Performance
Xtremу Mode - Enabled
CPU Level Ap - Auto
EPU Power Saving Mode - Disabled
Fully Manual Mode - Enabled
CPU Core Voltage - 1.25
CPU Cache Voltage - 1.8
CPU System Agent Voltage - Auto
CPU Input Voltage - 1.900
Dram Voltage - 1.21
CPU Spread Spectrum - Disabled
BCLK Recovery Enabled

I think thats CPU because only cpu_led stuck lighting red near 24pin connector...
And Yes, all fans are conect and working, cpu fan too - its Fractal Design Kelvin S36.
Last Idle temperature was 36 celsius and 55-62 on load.

caramba1
Level 7
Sorry, it was 1.18 of course )

caramba1
Level 7
Send motherboard to the seller for diagnostics.

What happened? I just got this AF too but mine does 14 then AF and cpu led 😞

msimax
Level 7
just had this issue for a week it was the cpu