08-22-2015 11:31 AM - last edited on 03-06-2024 02:09 AM by ROGBot
08-22-2015 01:21 PM
08-22-2015 01:34 PM
kkn wrote:
there is a gap between the heat sink and the module it self, you can even install a light bar on it.
i would use paint that cover lots on a thin layer.
but the spreaders it self sits under the silver alu bar.
08-23-2015 01:58 AM
08-23-2015 05:48 AM
Arne Saknussemm wrote:
Those fins are basically for show...bit of bling...under them is a pretty crummy heat pad..they are painted already...
And as K says the make no contact with top aluminium bridge so you could paint that with polar bear grease and it wouldn't affect heat dissipation 😉
08-23-2015 11:44 AM
08-23-2015 01:14 PM
kkn wrote:
nice nice, next? more pc parts maby? 😛
or a 2'nd or a 3'rd monitor? 😛
08-27-2015 02:05 AM