I got my new kit yesterday and today i got time to upgrade. Bios was updated earlier at 1504.
I cleared CMOS from board button and restart the computer.
Got into bios and memory kit was visible. but at 2133Mhz (DRAM voltage on auto 1.200V).
I checked CPU System Agent Voltage and value indicated was 1.072V [I noted this one for later use].
[my XMP DDR4-3000 overclock settings]
Changed AI Overclock Tuner from Auto to XMP and choose my XMP profile: XMP DDR4-3000 15-17-17-39-1.35V.
BCLK Frequency became 100.00 and DRAM Frequency became DDR4-3000Mhz. DRAM Voltage was set to 1.3530V.
Even if my input value was 1.35 bios register as value 1.3530 as voltage. Can't argue with that.
Rest of voltages stayed on auto (CPU Core/Cache, CPU VCCIO, CPU System Agent, PCH Core and CPU Standby).
Saved configuration and reset and got a beautiful Q-code 55 [memory not installed]. Shutdown computer and PSU. Removed both memory and reinstall them. Power my PSU and start computer again (code A0 = good). Overclock Failed and press F1, no worry. Booted with DRAM at stock speed 2133, got into win7 x64bit and ran realbench just for fun (@2133 with timings 15-15-15-36-2T @1.2V). Passed benchmark and stress test for 15min with 16GB RAM, again just for fun. Restart to get into bios and my XMP DDR4-3000 overclock settings are still there. So I change only CPU System Agent Voltage from Auto to 1.220V, based on the fact that bios indicate me 1.208V, so I need to add only +0.010V. Saved configuration and reset. Overclock failed again and press F1.
Got back into bios and changed CPU System Agent Voltage to 1.083V. Bios register as value 1.08750V and saved and reset again. I did this by adding +0.011V to my initial CPU System Agent Voltage noted at stock speed (@2133 voltage was 1.072V).
And it worked. And manage to install
Kingston HyperX Savage Black HX430C15SBK4/16 with 15-17-17-39 2T @1.35V