03-16-2016 12:44 AM - last edited on 03-06-2024 02:36 AM by ROGBot
03-16-2016 01:07 AM
03-16-2016 07:01 AM
03-16-2016 08:07 AM
ijgg10 wrote:
I installed these components in a complete new configuration
Mobo MAXIMUS VIII GENE Rev 1.03 Bios 1504
CPU I7 6700T- 2.8 GHz
Mem 16 GB (2x8) DDR4 Corsair Vengeanze LPX DDR4 CMK16GX4M2B3200C16 3200 GHz
The first times the mobo displayed 55 code, "memory not reconized",
So I updated the bios to the last version, since that not post and 00 code displayed,.
It is possible that the ram is it too fast for the cpu ?
or the system slow it down to 2133 that is the highter speed supported by the micro?
Could this have damaged the cpu or the mobo? or it is only a bad configuration issue.
Any Clue?
03-16-2016 08:44 AM
03-16-2016 03:23 PM
ijgg10 wrote:
I have reset the cmos with backpanel button, also I removed the battery for a couple of hours and restart again.
I took off the cpu and check then pins, I unplugged the power conectors and switch on again, I download lower bios versions and again the last version,
I lossened a little the heater and now I have bought new memory from amazon
Corsair CMD16GX4M4B2133C10, that I´ll receive tomorrow,
I think that it is my last chance before sending the mobo back to amazon to replace it.
But for the moment always code 00 displayed, It is very frustrating.
03-18-2016 04:08 PM
03-19-2016 11:57 AM
03-16-2016 08:47 AM