Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Tightening The Hold downs Corsair H100i ?

transmaster
Level 7

‎07-11-2016 09:33 PM - last edited on ‎03-06-2024 02:03 AM by Community Admin

Curious I have a precision 1/4" torque wrench that is calibrated in inch/pounds, if I used it to tighten the holds downs on the water pump section of my Corsair H100i on the CPU how tight in inch/pounds it should it be. Using such a tool would assure even tightening of the 4 hold down nuts.
Labels:
0 Kudos
3,110 Views
2 REPLIES 2

sectionate
Level 12

‎07-13-2016 02:20 PM

u shouldnt be using any tool to tighten down your cpu
Crosshair IV 1090T 4093.7 - Crosshair V FX - 8350 Batch # 1243PGT 4.422MHz - 4816.08 MHz 1.5v - GSKILL F3-14900CL9D-8GBSR(x2)1087.6 11-12-10 1.5volts - ViewSonic VX2439wm - Acer GD235HZ - SyncMaster P2350 - PowerColor Red Devil RX 480 8GBD5-3DH/OC - Current Mode: 5760 x 1080 - (retired) ASUS GTX660DC2O2GD5 - Nvidia 3D Vision Wired - HAF 932 - Corsair HX850 - Corsair H100i - latest quakelive.com - Day thirteen 60fps - as always I'm powered by Futurelooks.com
0 Kudos

meankeys
Level 13

‎07-13-2016 02:56 PM

They want them finger tight. More important evenly tightened. use a crisscross pttern when tightening.
0 Kudos