Hello everybody
I am using the Rampage V Edition 10 motherboard and the i7 6950x. Ok I upgraded from the i7 5960x a month ago and also oppted for the Samsung 960 pro 512 and everything has been ok well sort of.
Now I have had an issue were I change a setting in bios for overclock and save the setting and then I lose the Samsung boot manager and I have the reacuring boot in to bios. Getting it back is pain staking to say the leased. After managing to get a 4.4 overclock I set everything back to 3.6 via the overclocking profile which was all good. This morning I switched the pc on and it switched itself off, done some sort of reset and started again. Now after the bios screen I get the Edition 10 logo screen for about 2 seconds and bang I'm in Windows.. No dotted circle to say it's loading Windows just bang straight in. Normally it would show and disappear 3 times before Windows loaded. I am using bios 0901 which was more stable than 1002/3. I'm not sure why I lose the boot manager if I change a setting for Auto to a manual entry on the CPU voltage. XMP PROFILE works fine set at 3200 for Gskill Ripjaw 3200. I'm somewhat confused can anybody shed some light on this ?
Phanteks Enthoo Elite, Asus Rampage VI Extreme Encore, Intel I9 10980XE, G.SKILL F4-3200C14Q-32GTZ Trident Z Series @3200, 2 x EVGA Hydro Copper GTX 2080TI, Creative Sound Blaster ZxR PCI-Express Sound Card, EK ASUS ROG R6EE RGB Monoblock, 2 x Samsung 970 Pro 512GB Direct to CPU, Aqua Computer kryoM.2 with Samsung 960 Pro 512GB PCIe slot 4, 4 x Corsair XTI 480GB SSD, Aqua Computer Aquaero 6XT, 2x Aqua Computer D5 NEXT pump with Aquabus interface, 2 x XSPC 480mm Rads, EVGA 1600w PSU and more