Results 1 to 1 of 1
  1. #1
    ROG Junior Member Array
    Join Date
    Apr 2018

    FurMark ROG Edition - Vulkan test artifacts on RX580


    So I thought I had a problem with Vulkan on my new ROG STRIX RX580 GPU. I went into the AMD section and found another user with the exact same issue, here:
    The issue? Well, this doesn't look too good:

    The artifacts you see only show up with the artifact scanner enabled, without it, everything is good:

    So I asked on another forum, and one user offered to install the same Furmark software ( FurMark ROG Edition v0.6.1.0 ) and run with their Sapphire RX580 Nitro+. They noticed the exact same behaviour: Vulkan+Scanner = artifacts, anything else is ok.

    I'm not sure if this is the right place for this post, or if FurMark is out of your hands, but I'm relatively sure this is a software issue. Neither different drivers nor Vulkan versions installed has had any affect on this.

    Best regards,
    Last edited by Mattedatten; 04-18-2018 at 05:01 PM. Reason: More info

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts