1)Download the EUFI BIOS tool:
http://www.mediafire.com/?197177m6dcht1h22)Download the Bios file for your board
3)Download whatever Intel Rom version you wish to use "search google" MAKE SURE YOU USE CORRESPONDING IRST & INSTALL THAT FIRST Latest IRST can be found here
http://www.station-drivers.com/page/intel%20raid.htm 11.0.0.1032
4) Run the MM Tool inside the first link.
5) Click Load Image button on left and point it to your bios file.
6) Click on the Replace tab
7) Click browse button next to Module File and point it to the new Intel Rom File that you downloaded eairler
😎 Put a check mark in the box under link present & Make sure Vendor ID & Device ID match your hardware usually 8086,2822 DOUBLE check you hardware by going to device manager & expand storage controller double click Intel Sata Raid controller go to details and under property pull down matching device id there you will see the two sets of numbers i mentioned earlier.
9) Scroll down untill you find file named CSMCORE & Highlight it by left clicking on it once
10) Click the replace button wait a few seconds
11) Click save image as.....name it and save and some people say to wait 30 seconds before clicking close or exiting out of the program.
All credit goes to Fernando 1;) from my digital life forums for teaching me.
Hope this works well for you. If you have any doubts try it on your second Bios chip first. Please post your results as this info and tools were hard to come by. Thanks again Fernando!
PS: I am pretty sure the next Intel Raid Rom release will enable support for TRIM on SSD's in Raid array! About time!
"Those who are willing to give up freedom for security deserve neither"
Ben Franklin
Asus Maximus IV Extreme Z
Intel I7-2700K OC to 4.7 @ 1.330 volts
2X EVGA 660TI SLI
G.Skill Ripjaws Z 2133Mhz
2x Samsung 840 Pro 256GB SSD. Raid 0. 1 500gb WD VelociRaptor
Antec Gamers edition Bronze rated PSU 750 Watts
Corsair H80 Closed loop CPU cooler
Dragon Test Bench Case