05-18-2017 03:00 PM - last edited on 03-05-2024 10:16 PM by ROGBot
05-18-2017 03:29 PM
BlueScreen wrote:
I am attempting to install the monoblock. I applied thermal grease on the CPU and put the monoblock in place. As you can see the monoblock is not making contact with the CPU because the thermal grease did not spread out. The photos below were taken after I removed the monoblock from the motherboard to validate proper contact with the CPU. There are 2 screw holes nearest the IO Shield that have to go into the holes in the motherboard so that the monoblock can be properly seated. I confirmed that it was indeed fully seated.
05-19-2017 03:37 AM
Chino wrote:
Did you screw in the monoblock? Or did you just put it in place and then removed it?
05-18-2017 05:07 PM
05-18-2017 11:38 PM
05-19-2017 03:38 AM
Zka17 wrote:
I am tired and my eyes hurt, but can not see the exact model of the board and monoblock in your post...
Could you share?
05-19-2017 04:53 AM
05-19-2017 06:33 AM
05-19-2017 01:49 PM