08-20-2017 09:26 AM - last edited on 03-05-2024 09:44 PM by ROGBot
08-20-2017 09:30 AM
08-20-2017 09:35 AM
08-20-2017 09:52 AM
08-20-2017 10:24 AM
08-20-2017 10:51 AM
08-20-2017 11:11 AM
Mikan02 wrote:
Have a look at this thread over at AMD, it helped me 🙂
https://community.amd.com/thread/219286
You need to apply some pressure to top of the load plate when entering screw 1,
just slightly enter it cause to much will give trouble with 2 and 3.
Possible that you need to >slightly< move the load plate towards or from the
IO shield to make screw 1 enter, there is some room for movement without bending it
(Not the frame holding the CPU).
When moving over to screw 2 do not release pressure on top of the load plate,
try have equal pressure top and bottom when starting on screw 2.
When all 3 enters you can tighten all screws properly and release pressure applied to the load plate.
Hope this helps, used 20 min myself 😛
08-20-2017 11:35 AM
08-20-2017 11:48 AM