Results 1 to 6 of 6

Threaded View

  1. #1
    New ROGer Array
    Join Date
    Sep 2017
    Reputation
    10
    Posts
    8

    RAID Killing system

    I built my system, fresh install of Windows 10 Pro, installed all the updated drivers and it was running great, Then it was time to setup my RADI1 using 2 4TB drives and that's when things started too happen. The computer would not wake from sleep. When I rebooted it would take five + minutes to restart. If I shutdown the system all the fans would still be on but the screen would be black and I would just hold power button to power it off. Then when it finally started I just let it idle for awhile and then the video card fan ramped up to 100% and I was able to here it in another room, so I held the power button to bower it off nd then I disconnected the 2 RAID drives and everything back to normal. I then tested both hard drives using WD diags and they both based. Put both hard drive back on and now doing the same thing again, Is there a setting in the rad setup that I need to try and change? I have the caching to read only should I try read/wright? I really need help on this new build.

    Specs Below:

    AMD Ryzen 1800x
    Asus Crosshair VI Hero
    CORSAIR Vengeance RGB 32GB (2 x 16GB) 288-Pin DDR4 SDRAM DDR4 3200
    XFX Vega 64 Air Cooled
    Corsair HX1000I
    SAMSUNG 850 EVO 2.5" 1TB SATA III 3D NAND Internal Solid State Drive
    2 4TB Western Digital Black drives in RAID 1 for data

    Thanks,
    Dennis

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •