11-29-2017 01:02 PM - last edited on 03-06-2024 08:41 PM by ROGBot
11-30-2017 07:09 AM
12-04-2017 11:27 AM
12-04-2017 05:03 PM
12-05-2017 12:42 AM
P-Dub wrote:
There is definitely a sensor on the non-Wifi Max X hero. When I first installed HWiNFO64 (v5.60-3280) it asked if I wanted to enable an embedded controller because of compatibility reasons with other monitoring software. I clicked yes.
Under ASUS EC it shows VRM, PCH, CPU Vcc Sustain/Standby (VCCST_A), CPU PLL, VCCMP, and CPU_OPT fan. My temps are showing 47 current, 23 minimum and 62 maximum for VRM.
Hope this helps.
Menthol wrote:
It does not show on the Wifi model, also CPU-Z reads half vcore. I would think there is a VRM sensor just unreadable on the Wifi for some reason.
That said with a little airflow over the VRM you will have no issue, I don't have any VRM heat issue with no direct airflow, just what the exhaust fans above the board. I did set a 40mm fan on top of my Vid card cooling the M.2 heatsink which lowered 960 pro temps almost 10c.
12-04-2017 07:55 PM
12-05-2017 03:07 AM
12-05-2017 09:30 PM
no1yak wrote:
Well, VRM is not showing up in HWInfo64 on either the Hero X or my Hero IX.
Edit:- Checked for VRM sensor in the bios under monitor- not there. Tried bios 0505, not there. It appears that some boards have and some don't.
Someone on the Aida forum was asking why the VRM was not shown when in the bios the VRM sensor is.