I have a question, Im still getting bubbles in 1 part, but I don't see a leak. Every time I start my computer a few decent size bubbles appear inside the tube where the inlet on the cpu block is, and just gets stuck there. I go into bios, ramp up my pump speed to push it through and it travels to the resevior and floats to the top, out of the loop. (ive done this 5 times or so to try to get rid of it)
The only thing I can think of is that the rotary 45 degree fitting isn't properly sealed, or there's something wrong with the formula x ek crosschill block. What are the chances that air is getting into the loop, but water isn't getting out?
I built this around 3 weeks ago, I would've thought the bubbles would have worked its way out by now.