02-02-2018 07:46 PM - last edited on 03-06-2024 09:25 PM by ROGBot
02-03-2018 12:11 AM
02-03-2018 09:21 AM
Silent Scone wrote:
When re-enabling QFAN, have you tried manually selecting PWM?
02-03-2018 05:17 AM
02-03-2018 09:41 AM
Menthol wrote:
On Corsair AIO's there is a sata connector for power to the pump, a single wire that reads pump speed and the fan header from the pump to dual fans, how do you have them connected? If you have 2 fans connected to one fan header with an adapter the speed will not be read correctly.
My suggestion is connect the pump speed connector to the AIO header so you can see the pump speed (leave on default in bios), connect the 2 radiator fans to the CPU and CPU_OPT fan headers, set on Standard or Turbo or set up manually if you prefer, this will give you bios control over the radiator fans and speed should be read correctly.
Trust me other than for a short time you will not want to run those fans at full speed, the noise will be terrible.
02-03-2018 01:14 PM
tkemp66 wrote:
How I have everything connected:
Two fan headers from pump connected to the Corsair fans
CPU fan header is connected to the CPU fan connector on MOBO
Corsair link cable connected via USB on pump and into the 8 pin USB connector on MOBO
I assume this is the way everything should be connected. When you refer to power to the pump from SATA connector, power to the pump looks like it comes from MOBO CPU fan connector. My old H100i did come with a power connector for the pump, but not this current model.
02-03-2018 11:35 AM
02-03-2018 11:47 AM