Rome to Milan Dual BIOS update SOP | Official Support

FAQ

Product ESC4000A-E10

Rome to Milan Dual BIOS update SOP

1.Use Rome CPU to boot up.

* If no Rome CPU, please install each one of the supported CPUs

and plug in the power cable. The BMC LED will light up once the

on-board BMC is active. Please go to router/switch to get DHCP

to assign IP to login WEBUI.

2. Log-in WEBUI to update BMC with FW 2.3.1

a. Choose “Maintenance” and then “firmware Update”

2. Log-in WEBUI to update BMC with FW 2.3.1

b. Choose BMC FW 2.3.1 file to Start firmware update

3. Upon BMC FW completion, log-in WEBUI again and use

BIOS update function to update BIOS 0201 with CAP file

a. Choose “Maintenance” and then “BIOS Update”

3. Upon BMC FW completion, log-in WEBUI again and use

BIOS update function to update BIOS 0201 with CAP file

b. Choose MILAN BIOS 0201 to start BIOS update

4. Upon BIOS completion, shut down and reboot

5. Now the motherboard is with BIOS 0201 and is able to

boot up with both Milan and Rome CPU

Yes No

Above information might be partly or entirely quoted from exterior websites or sources. please refer to the information based on the source that we noted. Please directly contact or inquire the sources if there is any further question and note that ASUS is neither relevant nor responsible for its content/service
This information may not suitable for all the products from the same category/series. Some of the screen shots and operations could be different from the software versions.
ASUS provides the above information for reference only. If you have any questions about the content, please contact the above product vendor directly. Please note that ASUS is not responsible for the content or service provided by the above product vendor.
Brand and product names mentioned are trademarks of their respective companies.

ASUS Support FAQ