[Computer Chassis] ROG Hyperion GR701 Case FIO Module Replacement
Notice
1. Kindly wear gloves to protect your hands before proceeding with disassembly or assembly. Pay special attention to the corners of the parts to avoid any scratches.
2. When the side panel or front panel is made of glass, please handle it with extreme care during disassembly to avoid any collisions, falls, or undue stress.
3. When disassembling, please lay the casing flat on a stable surface to prevent the side panel from falling during the process.
4. Kindly ensure that the relevant wires are neatly arranged during assembly to prevent any damage to the wires throughout the process.
5. Keep track of all screws and small components during disassembly and assembly to avoid losing any parts.
Preparation
Tool: Phillips screwdriver PH2
1. Remove the top cover filter.
2. After loosening the screws, remove the top fan bracket.
3. Removing the FIO Panel Cover
(1) Use your thumb to press down on the front of the FIO panel.
(2) Use your index finger to pull back the FIO panel on both the left and right sides of the panel.
(3) Lift up the panel cover.
*Please refer to the video below
4. Remove FIO left and right screws.
5. Remove left and right Cables.
6. Open the side panels and wire cover, and loosen the devil's dip straps and cable ties.
7. Remove the signal cable from the FIO to the FAN HUB.
8. Pull out the FIO cable along the hole and remove the FIO body.
9. Replace the FIO with a new one, make sure there is no abnormality in the appearance and keypad, and then assemble it back in order.