[Gaming Cases]ROG Hyperion GR701 installation EATX motherboard notes | Official Support

FAQ

Product ROG GR701

[Gaming Cases]ROG Hyperion GR701 installation EATX motherboard notes

Please adjust the sequence of installation.

1. Remove VGA holder
(1) Remove the screws of the VGA holder.

(2) Pull the VGA holder upwards to remove it.

2. After removing VGA holder, MB can fit into chassis directly (No need to remove rear 14CM fan).
3. After MB installed, put VGA holder back if needed.

Visit ASUS official website to learn more about ROG Hyperion GR701 https://rog.asus.com/cases/rog-hyperion-gr701-model/

Was this information helpful?

Yes No

Above information might be partly or entirely quoted from exterior websites or sources. please refer to the information based on the source that we noted. Please directly contact or inquire the sources if there is any further question and note that ASUS is neither relevant nor responsible for its content/service
This information may not suitable for all the products from the same category/series. Some of the screen shots and operations could be different from the software versions.
ASUS provides the above information for reference only. If you have any questions about the content, please contact the above product vendor directly. Please note that ASUS is not responsible for the content or service provided by the above product vendor.
Brand and product names mentioned are trademarks of their respective companies.

ASUS Support FAQ

MyASUS