It started last night. I was trying to run through the adaptive mode overclock process again and after getting a stable setup, i noticed the package temp was way out. I don't use the iGPU and it is set to multi monitor off in the bios.

I have a feeling I'm doing something wrong here, and I probably don't understand adaptive mode so I hope you guys can help. My working settings are as follows:Vcore - Manual 1.335CPU Current Capability - 130%Phase Control - Ultra FastSwitching Freque...

Yesterday my board decided to die on me when I swapped the USB 3 connector from bottom to the side connector, I think I bent a pin and shorted it or something. Anyway, I replaced the board today under store warranty only to find that this one had BIO...

Hi All, Thank you for the forum for the advice I've found here. I have noticed that since changing RAM to G.Skill F4-3200C16-8GVK and setting XMP in the bios there now seems to be an occasional Q-Code of 40. When turning on the machine it will always...

Hey all, and thank you for the forums. When I built this system, to save money on buying another SSD, I took the Crucial MX100 256gb SSD from my laptop and put it in the desktop. When installing windows 10 I went through the usual steps during the in...