What hardware info do you need? This G30AB has i7-4770k, 16gb ram, 128gb ssd, gtx 780 etc.
So the case is this, I think I have not made myself clear enough. 🙂
When I updated bios. I went to the bios settings. I pressed save&exit and bios said nothing have been changed, exit anyway? I did not exit. I pressed F5 for 'load optimized defaults'. As was suggested by Asus EasyUpdate when updated bios. G30AB automatically changed these values when I pressed F5 :
CPU Load-Line Calibration [Auto] -> [Level 8]
CPU Voltage Frequency [Auto] -> [Manual]
CPU Fixed Frequency (kHz) [250] -> [500]
CPU Power Phase Control [Auto] -> [Extreme]
Then I did save&exit.
So those values are 'optimized defaults', I suppose.
I have not changed anything manually. Anything.
Now, if I go to bios again. And press F5 again, it tells me that the following values will be changed :
CPU Integrated VR Fault Management [Disabled] -> [Auto]
Link Status [Connected] -> [Disconnected]
These values I have NOT accepted and not saved.
Should I just go to the first values after updating BIOS? I should NOT 'load optimized defaults' at all?
Just go to BIOS after updating and save&exit without touching anything?
It was like that when I had 0601 BIOS. Never touched anything before now when updated to 0602 chose to 'load optimized defaults.
And yes, I have Bluetooth in my G30AB.