I have set up RAIDs before but I am having a hard time with doing it on the R5E. I can't seem to get to the correct page to set up the array.
I have two, Samsung 850 SSD's 250 Gb each, and I want to set them up as a RAID 0. This will not be my boot drive.
They are plugged into the top two ports as you look at the motherboard ( no's 1 & 2 I believe)
I have set all of my drives to RAID in the BIOs from ACHI (not my M2 XP41)
I hit Ctrl I as it boots up as the instruction manual says and it just goes into Windows.
So is it Ctrl "I" as in capital I and I have to hold the shift key down?
Is it Ctrl l as in a lower case L?
Is it something else?
What else should I be doing?
Simple, idiot proof directions would be appreciated. Once I get into the setup screen, I hope to be OK but any advice would be appreciated
5930K @4.5
ASUS Rampage 5 Extreme X99
16 Gbs Corsair Dominator 2666Mhz RAM
Two, EVGA Nvidia Titan X's in SLI
Samsung XP941 M2 512 Gb M2 boot drive
EVGA SuperNOVA P1200 PSU
Case Labs Merlin Full Tower
NZXT Kraken X61 AiO CPU cooler with four 140mm Noctura Industrial fans
Overlord Tempest O27X Monitor @ 118 Hz