12-20-2011 09:15 PM - last edited on 03-05-2024 07:30 PM by ROGBot
12-21-2011 01:44 AM
BrodyBoy wrote:
If it's working okay, sounds like there's no problem. 🙂
12-21-2011 11:15 AM
BrodyBoy wrote:
If it's working okay, sounds like there's no problem. 🙂
fuzon1337 wrote:
As BrodyBoy says:
If you detect any issues with the end of the antenna cable touching EM shield, then you could try to push the white antenna a little further up to the chassis.
if you remember how the cables were before you changed your network card, then you might try to make it look like it did before with the old card 🙂
12-22-2011 10:01 AM
12-22-2011 10:35 AM
12-22-2011 10:43 AM
12-22-2011 11:13 AM
JRd1st wrote:
You're worried about that connector touching the shield? I checked with my multimeter and they are electrically connected whether they touch or not, so no problem. That part of the wire is shielded and so is the outer connector. (I guess the antenna wire is exposed someplace else down the line.)